But in game, I pull the joystick trigger, F1, thinking I’ll get a cursor to pop up but I get nothing. I then saved my changes and can see my custom profile as being the one that is selected in the main control settings menu (not the quick toolbar menu). I just attempted mapping the cursor toggle to the trigger, F1, with the scan function, and it shows up as ‘A’ in the custom profile. Only the default is shown as being available. It shows my T.Flight as the default controls, and the default profile is chosen, but when I try changing the default profile to my custom profile, nothing happens. That’s not the entire issue I am having - I cannot select the custom profile in the quick menu (toolbar). I was hoping it would just plug n play with this Series X Flight Simulator. My Thrustmaster works fine with Star Wars Squadrons, Elite Dangerous, and Ace Combat 7. I’m quite frustrated at the moment with getting the HOTAS to work correctly with Flight Simulator. I tried like 20% dead zone to alleviate the gyrations. At the extremities, it cannot seem to determine where the stick is positioned and goes from full on to wherever it feels like and back again every time I move the stick even a little bit. The plane gyrates up and down with only the smallest hair movement on the stick. I tried adjusting it, but cannot complete the training missions with an A rating: for example, I cannot hold the climb or descent for 20 seconds steady. I cannot activate the cursor with the flight stick and am stuck going back and forth with the flight stick and my controller. It does not remember my sensitivity settings for extremity dead zone and responsiveness, despite the fact that I save my changes. Also, the wrong buttons get assigned when I try to create a custom controller profile - the buttons seem to be mislabeled.
0 Comments
Leave a Reply. |